...don't buy them. Your opinions on how they look are completely subjective. There are quite a few other options out there as far as mud guards go: ARK, ROKBLOKZ, OEM (especially the Canadian ones), Weather Tech, Rough Country, and on and on! There are related posts all over this site to browse...
Check out Ark as they worked with me on a new design for the 2024 Tacoma.
Doesn't hang out as far(slightly narrower), hair shorter, and no kink on the outside edge.
So far they work great and look good IMHO.
do you have a photo of how the front mud flaps mount? I’m curious to see if the ARK flaps would fit with the NYTOP carbon fenders and with the crash plates removed.
I changed to the Canadian R50s from the ark flaps.. the ark covered a little more but in my opinion they looked like shit.. didn’t do my Trailhunter any justice in the looks department .. love how the Canadian ones look and they don’t make the truck look cheap
Yes, to my knowledge ARK only makes these for the front. Rough Country is also the only mfgr of these for the rear. I’ve got both, just looking to keep it a bit more tidy over time.
The screws go into the grommets that are already inside your wheel well. In the rear, there is one factory hex screw to remove (there were three in the front ones, so it was more obvious). See the first picture in my post above, and you can see where they go. You should’ve been sent 3/4” long...
How did you get the top bolts to screw in the back? The bolts that come with these are too short. Did you use the push clips as well? Not sure where they would go and starting to think Ark sent the wrong hardware
What did you end up doing on the top bolts? Looking everywhere i know to find something similar that's a tad longer. Also emailed Ark yesterday and havent gotten a response