I just ordered the full ARB bed rack. The dealer had this rack installed on a TRD OR, and it is installed above both cameras located in the center high mount stop light assembly. However, the dealer did not have the HD kit installed. As the HD kit is essentially a thick tube that is installed...
I 100% agree with the JBL being absolute garbage. I've looked into adding the $300 amp to bump the levels in the rear, but that's more of a hack than a solution. Also, I'm hoping a future firmware update will allow independent volume control of the center channel
Which on-board jack should i carry if I'm doing the Wescott 2.5" / 35x12.50R17 upgrade? I don't know much about this stuff, so thanks in advance for your help!
This has happened to me three times so far. My TRD Sport has less the 4k miles. Turning the ignition off then back on has restored the cameras each time
My approach would be this:
1. Use blue painter's tape on the outside to hold the pieces together
2. Apply a thin strip of fiberglass cloth to the inside
3. Let resin cure, remove blue tape