Ragofabrication center console molle panels installed

[AltarBoy]

Installed these molle panels from Rago fabrication today. Overall the install wasn’t hard. Had to use a rivnut tool to mount them to the center console but they are very sturdy and aren’t going anywhere now. Looking forward to all the attachments and accessories I can put on them.

https://www.ragofabrication.com/col...ts/4th-gen-tacoma-center-console-molle-panels

Sponsored

 

[geonerdist]

Curious to see if you install anything with an arm, such as a phone holder using the threaded holes on the passenger side, if you have any flexing. I’ve noticed this, seems like it could be remedied with a third rivnut and bolt to the right of those two bolts that it seems to flex a bit from. I’ve reached out to Rago.

 

[AltarBoy]

Does it flex like that under regular driving over bumps or only when you grab it and wiggle around? I plan on mount my phone on the left panel and a mobile radio on the right panel.

 

[geonerdist]

Does it flex like that under regular driving over bumps or only when you grab it and wiggle around? I plan on mount my phone on the left panel and a mobile radio on the right panel.

Yes it causes a good bit of vibration and movement. The driver side one is solid.

Sponsored