Square or round amber marker lights (raptor lights) for grille?

[Kielly]

Long story short, bought some of these LEDs to put into my hoodscoop, bought the wrong side, correct size arrives today. Noticed though they'd fit perfect in the area shown below, but I don't know how they'd look as typically you'd do square in the grille, not sure if I ever seen round in the grille of a truck before and I don't want to risk mucking up my grille and making it look stupid lol.

These would be a TON more easier to install as you just drill a 11mm hole and slide them in, they screw in from the back, rectangular ones I would have to remove the entire grille/bumper combo to cut and install.

What do y'all think?

Sponsored

 

[goin2drt]

Option D. Three rectangular in the middle above the Toyota badge or hard pass. I don’t think that is going to look good on the right and left. Too far apart from each other but it is your truck. Do what you like as you are the only one that has to like it.

 

[Kielly]

Option D. Three rectangular in the middle above the Toyota badge or hard pass. I don’t think that is going to look good on the right and left. Too far apart from each other but it is your truck. Do what you like as you are the only one that has to like it.

I think you're correct in saying that. I'll have to do some digging. Find some lights that don't require a whole lot of cutting and rigging up to fit properly. If I could find some that sits flush and back screws like the round ones I can cut the grille on the truck

 

[tkrum015]

Will they fit in the sold area to the left and right of the Toyota badge?

Sponsored