CV Axle leak after King 2.5 install

[ArnoldN.]

Just for reference, here’s mine with 1.5 inches of front lift.
I don’t think yours looks bad at all. Sucks that it’s leaking, just clean it and watch? Maybe tighten the clamp with a CV boot clamp tool? Definitely wouldn’t replace the entire axel unless it’s dry or dirt gets in it.

Thanks MT-Taco. I found a small pinhole tear in my boot. I'm not sure If I moved everything at a bad angle during my coilover install ,but I am going the route of ordering a new bootkit. The axle hasn't given me any trouble at all even with leaking some grease.

Sponsored

 

[ArnoldN.]

Chloe Kuo just dropped a video where they did just that. Just an FYI. They do mention refilling the cv joint grease and dropping the front diff mount.

I watched this video and the guy from Icon kinda brushes over the diff drop not being as much of a problem on TRD off roads. That makes some sense as I was looking into replacing the CV axle or just the boot and every part I find is either W/TRD or W/O TRD.