emerica243
Active member
- Thread starter
- #1
12/27/24
First Toyota\Tacoma. Purchased an Off Road for $52k. It came with goodies like the Premium package, TRD performance exhaust, Tonneau cover and a few other little knick nacks.
**PLACEHOLDER FOR ORIGINAL PICTURES HERE**
1/4/24
1. Installed Go Rhino Dominator Extreme D6 running boards. 3 brackets for each side that went into the factory rocker panel bolt holes. Torque rating for bolts should be 20ish ftlbs.
**PLACEHOLDER FOR PICTURES HERE**
2. Installed RokBlokz rally size mud guards. 5 oem bolts came out to remove the factory mud guards and then you use the included hardware to install the RokBlokz.
1/7/24
1. Installed AlphaRex Nova Prismatic tails lights. Install was easy, 2 bolts, pull off the OEM light, swap the button (if you have it) put in two screws...BUT WAIT there were no screwed provided. And the screws out of the OEM assembly are a size or two too big to fit in the pre-made plastic holes in the AlphaRex assemblies.
AlphaRex on the left, OEM on the right.
OEM
AlphaRex
OEM
AlphaRex
2. Installed Lasfit switchback LED bulbs. Easy install, reach behind headlight and remove OEM bulb\connector\plug, insert new bulb, reinstall.
First Toyota\Tacoma. Purchased an Off Road for $52k. It came with goodies like the Premium package, TRD performance exhaust, Tonneau cover and a few other little knick nacks.
**PLACEHOLDER FOR ORIGINAL PICTURES HERE**
1/4/24
1. Installed Go Rhino Dominator Extreme D6 running boards. 3 brackets for each side that went into the factory rocker panel bolt holes. Torque rating for bolts should be 20ish ftlbs.
**PLACEHOLDER FOR PICTURES HERE**
2. Installed RokBlokz rally size mud guards. 5 oem bolts came out to remove the factory mud guards and then you use the included hardware to install the RokBlokz.
1/7/24
1. Installed AlphaRex Nova Prismatic tails lights. Install was easy, 2 bolts, pull off the OEM light, swap the button (if you have it) put in two screws...BUT WAIT there were no screwed provided. And the screws out of the OEM assembly are a size or two too big to fit in the pre-made plastic holes in the AlphaRex assemblies.
AlphaRex on the left, OEM on the right.
OEM
AlphaRex
OEM
AlphaRex
2. Installed Lasfit switchback LED bulbs. Easy install, reach behind headlight and remove OEM bulb\connector\plug, insert new bulb, reinstall.
Sponsored
Last edited: