Miles/KM not reflecting after putting gas

[TacomaCR]

hi,
l got a 2024 SR5 for some reason l cannot seem to have the miles/km of range updated once l get fuel…

this started to happen when i changed from 245/70/R17 HW toyo (factory) to 285/70/R17 MT these were too rough and big. Also it’s when i noticed the inconsistency.

Those were very bad for my liking and driving..

Then switched to 265/70/R17 RT and these are way better but still get fuel around 4-6 gallons and marks 40miles it for sure gives me more than that but l can only guide myself how much gas l got when l get in reserve

Sponsored

 

[CanyonFisherSummitSeeker]

This happened to me early on. Are you leaving the power/auxiliary on while filling up? If you are be sure to shut off the power/radio etc while it’s filling.

I haven’t heard or read anyone else say this so I don’t know if it’s common or not but the two times I listened to the radio while filling up I had this issue. The first time I was nearly convinced I’d been had by chevron but it finally updated after about 20 minutes of driving then turning ignition off and back on.

second time I made the connection to leaving the power running. Hasn’t happened since. Hope this helps.

 

[soupy1234]

Fuel gauge and driving range
display
The fuel gauge and driving range
display are linked. If the fuel gauge
and driving range display do not
update after refueling a small
amount, they can be updated by
performing the following procedure:
1 Stop the vehicle on a level surface.
Wait until the fuel in the fuel tank
stabilizers.
2 Turn the engine switch off.
3 While pressing and holding
of the meter control switch, turn
the engine switch to ON.
4 Continue holding of the
meter control switch for approximately
5 seconds.
Release the button when the odometer
begins blinking.
Updating will be complete when the
odometer blinks for approximately 5
seconds and then returns to the normal
display.

--Now if there were just a way to reset the stupid DTE calculation. Most people complain that there is too much reserve when they get near "0". I'm seeing the opposite. I usually get 23+ mpg. Then I go on a freeway trip and get 19-20. DTE is still thinking "23-24". I don't dare go to 0, and I worry about going below 1/4 tank if I'm not carrying extra gas.

 

[TacomaCR]

This happened to me early on. Are you leaving the power/auxiliary on while filling up? If you are be sure to shut off the power/radio etc while it’s filling.

I haven’t heard or read anyone else say this so I don’t know if it’s common or not but the two times I listened to the radio while filling up I had this issue. The first time I was nearly convinced I’d been had by chevron but it finally updated after about 20 minutes of driving then turning ignition off and back on.

second time I made the connection to leaving the power running. Hasn’t happened since. Hope this helps.

mmm l think the radio is running yes but the car turned off i’ll try and see again

 

[TacomaCR]

Fuel gauge and driving range
display
The fuel gauge and driving range
display are linked. If the fuel gauge
and driving range display do not
update after refueling a small
amount, they can be updated by
performing the following procedure:
1 Stop the vehicle on a level surface.
Wait until the fuel in the fuel tank
stabilizers.
2 Turn the engine switch off.
3 While pressing and holding
of the meter control switch, turn
the engine switch to ON.
4 Continue holding of the
meter control switch for approximately
5 seconds.
Release the button when the odometer
begins blinking.
Updating will be complete when the
odometer blinks for approximately 5
seconds and then returns to the normal
display.

--Now if there were just a way to reset the stupid DTE calculation. Most people complain that there is too much reserve when they get near "0". I'm seeing the opposite. I usually get 23+ mpg. Then I go on a freeway trip and get 19-20. DTE is still thinking "23-24". I don't dare go to 0, and I worry about going below 1/4 tank if I'm not carrying extra gas.

good tip what do you mean by meter control switch l don’t know where is it new to me

 

[TacomaCR]

good tip what do you mean by meter control switch l don’t know where is it new to me

so was a "hard reset"... press one time power bottom "power on" then press ok and power bottom till the car starts (WITHOUT FOOT ON BREAK) that did it

 

[soupy1234]

good tip what do you mean by meter control switch l don’t know where is it new to me

Center control on the left side of the steering wheel. Normal use is to customize the display.

Edit: Also, do NOT start the vehicle. Press start twice with foot off the brake.

 

[Wife bought my 24 TRD]

Center control on the left side of the steering wheel. Normal use is to customize the display.

Edit: Also, do NOT start the vehicle. Press start twice with foot off the brake.

Will this reset?
Everything

 

[TacomaCR]

Will this reset?
Everything

l did start n stop with ok buttom... NO FOOT ON BREAK and just reset my avg kms l use kms cause l am not in the US. but only reset that in ur case would only reset miles... if you talking about configurations u had no all stayed the same for me

Sponsored