ReadyLift 1.5" leveling kit for 2024 4th gen Tacoma now available

[Visa_Declined]

I bolt the spacer to the top of the strut then bolt that into the upper strut tower. You will see that the lower shock mount is now rotated about 45° off. Insert a long 3/8 extension into the lower shock bolt hole and give it a twist until the bolt hole aligns with the lower control arm holes.

Whether it's an extension used in the shock or something else, I can guarantee you that this is how most people are installing these.

Sponsored

 

[watkins303]

Anyone know if there is a way to get just a slight amount more height out of the lift kit so there is no rear rake? I'd like it to be actually level with the rear or just a very slight amount higher in the front.

I'm not seeing any options yet to get about a 2.0 lift in just the front.

 

[webshot]

just installed the 1.5” readylift leveling kit. All stock besides leveling kit. Looks great to me. Still a slight rake which I prefer and now it doesn’t look slammed in the front like before. Install was easy but a bit annoying to trim the OE strut top mount bolts. All in it was maybe 40 minutes, but I’ve installed a lot of these kits before.

Did you have to get an alignment after the install?

 

[oxi]

Did you have to get an alignment after the install?

Yes...

The dealer installed my level kit before I arrived to pick it up, and they did the alignment. I was their first 2024 Tacoma, so they had to calibrate the machine.

I once put a gussted idler arm on my 85 2wd on my own, never did the alignment before the trip to Arizona (Parker 400) and it chewed up my Mud's from Wisconsin.

 

[CsousaNH]

Will the ReadyLift 1.5 leveling kit work with a limited with AVS? The RC one will not. Any suggestions on a leveling kit that will work with the limited with AVS? I do not wish to purchase a coil over system and I am not taking the truck off road, just on some snowy conditions and dirt roads in NH. I just like the look without the signifiant rake.

 

[Paul85]

Anyone know if there is a way to get just a slight amount more height out of the lift kit so there is no rear rake? I'd like it to be actually level with the rear or just a very slight amount higher in the front.

I'm not seeing any options yet to get about a 2.0 lift in just the front.

https://www.readylift.com/2-5-sst-lift-kit-toyota-tacoma-2024.html

I think this is the path I'm going to go on my TRD Sport.

 

[The T Rav]

I’m going to go out on a limb here and assume none of you are towing or hauling anything with your trucks. Because if I were to level my TRD Off-road, I’d be staring at the sky when I tow my little (4,000#) camper or haul my dirt bikes in the bed. The rear springs seem very weak, it squats pretty severely even with only 200# of tongue weight or 500# in the bed.

Sponsored